start-network: Start network connection (use with options below)
get-client-id : Connect and get Client ID for service set-client-id ,: Set Client ID for service to mbim, -m NAME is an MBIM device with EXT_QMUX support release-client-id : Release Client ID after exiting keep-client-id : Keep Client ID for service device=NAME, -d NAME: Set device name to NAME (required) single, -s: Print output as a single line (for scripts) Here is a brief help about uqmi command line usage. Timeout (in seconds) to wait for SIM operations Whether to use dhcp ( 1) or uqmi ( default) to get IPv6 interface configurationįirst three digits are the mcc (mobile country code) and the last three digits are the mnc (mobile network code), for example if plmn=338020, then the mcc is 338 and the mnc is 020 Whether to use dhcp ( default) or uqmi ( 0) to get IPv4 interface configuration Used IP-stack mode, IP (for IPv4), IPV6 (for IPv6) or IPV4V6 (for dual-stack) Seconds to wait before trying to interact with the modem (some ZTE modems require up to 30 s.)Īllowed network modes, comma separated list of: all, lte, umts, gsm, cdma, td-scdma See Troubleshooting Section of this page for more information.Īuthentication type: pap, chap, both, none Or look info about USB devices and interfaces present in the system: Try dmesg to read kernel logs on USB init If you have no such device - try to find out what went wrong:
Check that everything is OK and You got new device:Ĭrw-r-r- 1 root root 180, 176 Oct 1 12:03 /dev/cdc-wdm0 Refer to your router Forum thread for possibility and instructions.ģ. If your have not enough space on your device - think of installing Rootfs on External Storage (extroot)Īnother option is Hardware memory upgrade.
#Usb To Pc Failed To Disable Rndis To Use Serial install
Opkg install usb-modeswitch kmod-mii kmod-usb-net kmod-usb-wdm kmod-usb-net-qmi-wwan uqmi
0 kommentar(er)
